Springfield Roof Pros provides professional chimney flashing in Springfield, IL for residential and commercial properties across Sangamon County and central Illinois. A masonry chimney is a separate building sharing a roof with yours. It stands on its own footing, while the frame around it stands on the foundation. Where the ground under one moves differently from the ground under the other, the flashing between them is the joint that pays.
That is why chimney flashing here fails in a way that does not look like corrosion. Corroded flashing thins, pits and weeps along its whole length. Sheared flashing pulls cleanly out of the mortar joint on one side, opens a wedge that is wide at one corner and tight at the other, and leaves the metal itself in perfectly good condition with no pitting anywhere along it.
There are two separate pieces in a correct assembly, and there always have been. Step flashing woven in course by course on both sides and lapped under the shingles, then a separate counter flashing let into the masonry above it, covering the step pieces without being fastened to them. Two pieces means each can move relative to the other without tearing, which is the entire point of the detail.
What we usually find instead is a single bead of roof cement smeared across the whole intersection. It works for two winters. On a house that is moving it works for considerably less, because the mass has nothing to give and simply cracks, and now the failure sits hidden under a black stripe that nobody can inspect, photograph or price honestly.
So on any chimney showing shear rather than ordinary wear, we build for service instead of permanence. Two-piece counter flashing that can be pulled and reset without cutting brick, a sawn reglet rather than a caulked surface mount, plus a cricket behind any chimney broad enough to catch water and debris. If the movement carries on, the next repair is an hour of work rather than a rebuild and a scaffold.
We also tell people plainly when it is time to stop spending. If the chimney itself is leaning, separating from the house, or opening a joint at the roofline that closes again seasonally, do not put money into flashing or tuckpointing yet. That is an engineer's question and a possible mine subsidence claim, and repairing the symptom first can complicate the engineering report and the claim at the same time.
Our licensed and insured team brings the right materials and equipment to every job — laminated shingles set six per course inside the fastening band, self-adhered ice barrier carried past the interior face of the wall plate, nominal one-inch plank decking overlaid with plywood before shingles, two-piece counter flashing set in a sawn reglet and left removable, step flashing woven course by course rather than sealed as one mass, twenty-four gauge striated standing seam on concealed expansion clips — and backs the work with a written workmanship warranty. We serve Springfield and nearby communities including Chatham, Sherman, Auburn, Rochester.
What We Handle
Everything our chimney flashing in Springfield covers
One crew, one point of contact, and the full range of chimney flashing work in Springfield, IL. If it is on this list we do it in house rather than handing it to a subcontractor:
- chimney flashing repair
- step flashing replacement
- counter flashing reglet
- chimney cricket
- chimney leak repair
- masonry chimney roof joint
- flashing shear damage
- chimney flashing replacement cost
- roof cement flashing failure
- saddle behind chimney
- chase cover
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Springfield services.
Materials, equipment and how we do chimney flashing
The difference between chimney flashing that lasts and chimney flashing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with laminated shingles set six per course inside the fastening band, self-adhered ice barrier carried past the interior face of the wall plate, nominal one-inch plank decking overlaid with plywood before shingles, two-piece counter flashing set in a sawn reglet and left removable, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Springfield job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in Sangamon County and central Illinois means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do chimney flashing outside Springfield
Springfield Roof Pros covers Springfield and the surrounding communities of Sangamon County and central Illinois. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Chimney Flashing in Chatham, IL — Sangamon County, population 14,377
- Chimney Flashing in Sherman, IL — Sangamon County, population 4,673
- Chimney Flashing in Auburn, IL — Sangamon County, population 4,574
- Chimney Flashing in Rochester, IL — Sangamon County, population 3,863
- Chimney Flashing in Riverton, IL — Sangamon County, population 3,532
- Chimney Flashing in Pawnee, IL — Sangamon County, population 2,678
Start on the Springfield Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Springfield Chooses Springfield Roof Pros
- ✓We run a string down the ridge before we price anything, because in Sangamon County an out-of-line ridge changes which coverage you are claiming under, and we would rather find that than quietly sell around it.
- ✓On a house that is actively moving we decline the replacement and sell you a tarp, a repair and a review date, because most subsidence movement happens in weeks but the rest of it can take three to five years.
- ✓We do not convert asphalt houses to tile. The dead load is an engineer's decision rather than a roofer's, and there is no local tile trade here to service the claim when pieces start breaking at the batten.
- ✓Chimney flashing gets built in two pieces that can be pulled and reset without cutting brick, because on a frame that moves, a sealed monolithic detail is a repair you end up paying for twice.
The standards behind chimney flashing
Quality here is not a matter of opinion — it is written down. The chimney flashing work we do in Springfield follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every chimney flashing project in Springfield gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free chimney flashing free estimate in Springfield, or request a quote and we'll get right back to you.